MP – Manual pulse generator

Block SymbolLicensing group: STANDARD

Function Description
The MP block generates a pulse of width pwidth when a rising edge occurs at the BSTATE parameter (off $\to$ on). The algorithm immediately reverts the BSTATE parameter back to off (BSTATE stands for a shortly pressed button). If repetition is enabled ( $RPTF = on$ ), it is possible to extend the pulse by repeated setting the BSTATE parameter to on. When repetition is disabled, the parameter BSTATE is not taken into account during generation of a pulse, i.e. the output pulses have always the specified width of pwidth.

The MP block reacts only to rising edge of the BSTATE parameter, therefore it cannot be used for generating a pulse immediately at the start of the REXYGEN system executive. Use the BIS block for such a purpose.

Output

Y	Logical output of the block	Bool

Parameters

pwidth	Pulse width [s] (0 means one pulse) $⊙$ 1.0	Double (F64)
BSTATE	Output pulse activation	Bool
	off .. No action on ... Generate output pulse
RPTF	Allow pulse extension	Bool
	off .. Disabled on ... Enabled

[Previous] [Back to top] [Up] [Next]