PARE – Block with input-defined enumeration parameter

Block SymbolLicensing group: STANDARD
PIC

Function Description
The block is similar to the the PARI block with the additional option to assign texts to numeric values. The corresponding text is set on the output sy. The block has two modes and the active mode is selected by the LIST parameter. If LIST=off a corresponding text for the input value is set on the output sy. If LIST=on the input number is considered as a bitfield, texts are defined for each bit and the output sy is composed of the texts that correspond to bits which are set. The behavior for undefined values is determined by the SATF parameter. If SATF=off, undefined values are set to output iy and the output sy is set to empty text. Undefined values are ignored if SAT=on. The pupstr parameter has the same format as in the CNE block: <number1>: <description1>|<number2>: <description2>|<number3>: <description3> ...

Inputs

ip

Parameter value

Long (I32)

LOC

Activation of local mode

Bool

off ..

The parameter follows the input

on ...

Local mode active

Parameters

ipar

Internal value of parameter  1

Long (I32)

pupstr

Popup list definition  1: option A|2: option B|3: option C

String

NUM

Number in string outut

Bool

LIST

Bitfield mode

Bool

SATF

Saturation flag (if undefined values are passed to output)

Bool

Outputs

iy

Integer output of the block

Long (I32)

sy

String output value

String

2024 © REX Controls s.r.o., www.rexygen.com