RS – Reset-set flip-flop circuit

Block SymbolLicensing group: STANDARD

Function Description
The RS block is a flip-flop circuit, which sets its output permanently to on as soon as the input signal S is equal to on. The other input signal R1 resets the Q output to off even if the S input is on. The NQ output is simply the negation of the signal Q.

The block function is evident from the inner block structure depicted below.

This block propagates the signal quality. More information can be found in the 1.4 section.

Input

S	Flip-flop set	Bool
R1	Priority flip-flop reset	Bool

Output

Q	Flip-flop circuit state	Bool
NQ	Boolean complementation of Q	Bool

[Previous] [Back to top] [Up] [Next]