ARLY – Advance relay

Block SymbolLicensing group: STANDARD

Function Description
The ARLY block is a modification of the RLY block, which allows lowering the amplitude of steady state oscillations in relay feedback control loops. The block transforms the input signal u to the output signal y according to the diagram below.

Input

u	Analog input of the block	Double (F64)

Output

y	Analog output of the block	Double (F64)

Parameters

ep	Value for switching the output to the "On" state $⊙$ -1.0	Double (F64)
en	Value for switching the output to the "Off" state $⊙$ 1.0	Double (F64)
tol	Tolerance limit for the superposed noise of the input signal u $↓$ 0.0 $⊙$ 0.5	Double (F64)
ap	Value of the y output in the "On" state $⊙$ 1.0	Double (F64)
an	Value of the y output in the "Off" state $⊙$ -1.0	Double (F64)
y0	Initial output value	Double (F64)

[Back to top] [Up] [Next]