PARE – Block with input-defined enumeration parameter

Block SymbolLicensing group: STANDARD

Function Description
The block is similar to the the PARI block with the additional option to assign texts to numeric values. The corresponding text is set on the output sy. The block has two modes and the active mode is selected by the LIST parameter. If LIST=off a corresponding text for the input value is set on the output sy. If LIST=on the input number is considered as a bitfield, texts are defined for each bit and the output sy is composed of the texts that correspond to bits which are set. The behavior for undefined values is determined by the SATF parameter. If SATF=off, undefined values are set to output iy and the output sy is set to empty text. Undefined values are ignored if SAT=on. The pupstr parameter has the same format as in the CNA block: <number1>: <description1>|<number2>: <description2>|<number3>: <description3> ...

Inputs

ip	Parameter value	Long (I32)
LOC	Activation of local mode	Bool
	off .. The parameter follows the input on ... Local mode active

Parameters

ipar	Internal value of parameter $⊙$ 1	Long (I32)
pupstr	Popup list definition $⊙$ 1: option A\|2: option B\|3: option C	String
NUM	Number in string outut	Bool
LIST	Bitfield mode	Bool
SATF	Saturation flag	Bool

Outputs

iy	Integer output of the block	Long (I32)
sy	String output value	String

[Previous] [Back to top] [Up] [Next]