SWU – Switch unit

Block SymbolLicensing group: STANDARD
PIC

Function Description
The SWU block is used to select the appropriate signal which should be tracked by the inactive PIDU and MCU units in complex control structures. The input signal uc is copied to the output y when all the binary inputs OR1, …, OR4 are off, otherwise the output y takes over the uo input signal.

Inputs

uc

This input is copied to output y when all the binary inputs OR1, OR2, OR3 and OR4 are off

Double (F64)

uo

This input is copied to output y when any of the binary inputs OR1, OR2, OR3, OR4 is on

Double (F64)

OR1

First logical output of the block

Bool

OR2

Second logical output of the block

Bool

OR3

Third logical output of the block

Bool

OR4

Fourth logical output of the block

Bool

Output

y

Analog output of the block

Double (F64)

2020 © REX Controls s.r.o., www.rexygen.com