DER – Derivation, filtering and prediction from the last n+1 samples

Block SymbolLicensing group: STANDARD

Function Description
The DER block interpolates the last $n + 1$ samples ( $n \leq N - 1$ , $N$ is implementation dependent) of the input signal u by a line $y = a t + b$ using the least squares method . The starting point of the time axis is set to the current sampling instant.

In case of $RUN = on$ the outputs y and z are computed from the obtained parameters $a$ and $b$ of the linear interpolation as follows:

In case of $RUN = off$ or $n + 1$ samples of the input signal are not yet available ( $RDY = off$ ), the outputs are set to $y = 0$ , $z = u$ .

This block propagates the signal quality. More information can be found in the 1.4 section.

Input

u	Analog output of the block	Double (F64)
RUN	Enable execution	Bool
	off .. Tracking on ... Filtering
tp	Time instant for prediction/filtering	Double (F64)

Parameter

n	Number of samples for interpolation $↓$ 1 $↑$ 10000000 $⊙$ 10	Long (I32)
nmax	Allocated size of array $↓$ 10 $↑$ 10000000 $⊙$ 100	Long (I32)

Output

y	Estimate of input signal derivative	Double (F64)
z	Predicted/filtered input signal	Double (F64)
RDY	Outputs valid (ready flag)	Bool

[Previous] [Back to top] [Up] [Next]