KDER – Derivation and filtering of the input signal

Block SymbolLicensing group: ADVANCED
PIC

Function Description
The KDER block is a Kalman-type filter of the norder-th order aimed at estimation of derivatives of locally polynomial signals corrupted by noise. The order of derivatives ranges from 0 to norder 1. The block can be used for derivation of almost arbitrary input signal u= u0(t) + v(t), assuming that the frequency spectrums of the signal and noise differ.

The block is configured by only two parameters pbeta and norder. The pbeta parameter depends on the sampling period TS, frequency properties of the input signal u and also the noise to signal ratio. An approximate formula pbeta TSω0 can be used. The frequency spectrum of the input signal u should be located deep down below the cutoff frequency ω0. But at the same time, the frequency spectrum of the noise should be as far away from the cutoff frequency ω0 as possible. The cutoff frequency ω0 and thus also the pbeta parameter must be lowered for strengthening the noise rejection.

The other parameter norder must be chosen with respect to the order of the estimated derivations. In most cases the 2nd or 3rd order filter is sufficient. Higher orders of the filter produce better derivation estimates for non-polynomial signals at the cost of slower tracking and higher computational cost.

Input

u

Input signal to be filtered

Double (F64)

Outputs

y

Filtered input signal

Double (F64)

dy

Estimated 1st order derivative

Double (F64)

d2y

Estimated 2nd order derivative

Double (F64)

d3y

Estimated 3rd order derivative

Double (F64)

d4y

Estimated 4th order derivative

Double (F64)

d5y

Estimated 5th order derivative

Double (F64)

Parameters

norder

Order of the derivative filter   2  10 3

Long (I32)

pbeta

Bandwidth of the derivative filter   0.0 0.1

Double (F64)

2023 © REX Controls s.r.o., www.rexygen.com